Leaves a lot to be desired for a machine shop. I took A&K an aluminum pulley I needed the center bore enlarged from 5/8 to 3/4. First time I got the pulley back the hole was the correct size but off center so bad I could not run the pulley due to wobble. So I took it back to see if they could correct their mistake and they said they would take care of it. This time I got the pulley back and they enlarged the hole and re-centered it then sleeved it to what I assumed was the correct size. Well to my surprise the new sleeve is .02 off and won’t fit on the spindle. I figured this would be a simple job for a machine shop apparently I was mistaken. I don’t think it’s worth giving them a 3rd shot even though I was charged $75 just to enlarge a hole 1/8.

Friendly and knowledgeable staff. It was a small job, but they still treated me like an important customer. Thanks to the team at A&K. I would use them again.

Great experience dealing with Keith,Very personal service and knowledgeable staff..Dropped off a custom project building a rudder for a large fishing boat and they easily understood exactly what I was looking for.

VERY pleased with service. Craig delivered great quality and has many years of experience. He and staff were all personable. Turnaround for this small job (motor shaft and moving sheave work) was 1 day. Id absolutely use them again.

Hands down the best! always willing to work with you & give you the best experience possible

You break it they make it!! They help keep everything running in many factories and assembly lines!

Fantastic fabrication shop. Ive used them multiple times, always top quality work.

Always great work

Grate place good work. And service .

Craig is always attentive and gets the job done for us. He does high quality work and is a man of his word. He goes above and beyond to help our company out whenever we have an Aircraft on the ground.

Very poor billing Dept. That does not keep good records.